3.5" Front Leveling Lift Kit For Chevrolet GMC Silverado Sierra 1500 2007-2020

Feature

Levels vehicle and eliminates vehicle rake.

Enhances appearance by giving the it a more even stance.

Offers extra ground clearance to use larger tires & wheels.

CNC machined billet aluminum construction for maximum strength and increased safety.?

Installation

Block off your rear tires and make sure your vehicle is parked with the emergency brake on.

Use a hydraulic jack (jacks from spare tire kits won’t be sufficient) and jack stands to lift your front two wheels off the ground. Refer to your owner’s manual for the correct jacking points to safely lift the vehicle.

Support with jack stands on the frame of the vehicle – do not rely on the jack to hold the weight of the vehicle while you work.

1、Remove your tires.

2、Once your tires are removed, raise your suspension with a floor jack on the axle so that the spring is compressed slightly. This will make it easy to remove.

3、Install your spring compressor onto the spring, making sure it’s secure.

4、Remove the spring retaining clip.

5、Remove the shocks.

6、Remove your sway bar link.

7、If the bump stop is located inside the coil spring, remove it. It should come out easily, and we suggest using pliers or a pry bar, but if not, feel free to add PB Blaster.

8、Lower the axle housing on the jack. Your coil should easily come out, held together by the spring compressor.

Note

Lift spacer thickness and lift is not a 1 to 1 ratio due to the suspension geometry.

This lift kit will raise the front of your Chevrolet/ GMC by a true 3.5".

This is our new 3.5” kit and it is a 2-piece kit comprised of an upper and lower spacers working together.

It has been found that kits that put all the lift on top of the strut experience some binding effect and will result in premature strut wear and early failure.

Therefore, we created the 2-piece lift eliminates this problem for years of trouble free service.

Can be installed in about 1 1/2-2 hours and does not require strut/coil disassembly like other kits.

They are CNC machined out of billet aluminum and then powdercoated black to match you factory suspension. The quality of this kit cannot even be compared to welded spacers that crack over time.

These spacers are the strongest on the market and come with a 100% satisfaction guarantee. It will come to you complete with all the hardware.

⚠️WARNING: This product can expose you to chemical which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.