O2 Oxygen 02 Sensor 07 Nissan Frontier INFINITI G35 Upstream 2Pcs

SSN oxygen sensors are manufactured with sophisticated technology, every sensor meets or exceeds OEM quality standards.

SSN offers parts and accessories for the perfect combination of quality and value. SSN products with an OE design, simple installation, and long life as a guarantee. Provides extensive coverage of Auto parts for a broad range of automotive and heavy-duty 4x4 wheel applications.

Get better driving experience and handling with high-performance Air Intake Systems and components that will keep you in control on road and off road over the bumps.

Features

• O2 Sensor can improve engine efficiency performance and fuel economy
• The fault code can be eliminated at less than half the cost of the OEM
• The oxygen sensor can solve the problem of poor gasoline mileage

Must Know Before Buying

The following information is for instructional and guidance reference only. We try and make them as accurate as we can.

• If Check Engine Light is on or an OBDII Trouble/Fault code occurs after installation, check the sensor with a voltmeter as below.
• If the sensor is good, further diagnosis is required. There're many different codes for specific functional failures, which are NOT necessarily relevant to the sensor. Find out what the Code means before leaving any feedback.
• Items that have been installed, altered, or contaminated are non-returnable.

Note

      1. ONLY a defective sensor after being tested by a voltmeter is applied to the manufacturer's warranty.

      2. 20% restocking fee is required if the buyer bought the wrong items due to not paying attention to fitment information and asking for a return.

      3. The Price, Quality & Functionality of the O2 Sensor is fully covered under our warranty & return policy. However, a refund for any labor cost, expense in a dealer shop, or damage due to the wrong installation is NOT covered.

How to see a bad oxygen sensor?

The bright orange “Check Engine” light burning. This alert is almost always the result of a tripped oxygen, aka O2, sensor. Another warning sign could be the message on your car’s computer that there is a heater circuit malfunction. When you see the Check Engine Light (CEL) or heater circuit malfunction message it could mean that your O2 sensor has simply gone bad.

How to install an oxygen sensor?

Step 1: Disconnect the electrical connection on the oxygen sensor. Step 2: Unscrew the oxygen sensor off the exhaust pipe using either a wrench or remove it. Step 3: Cut off the connector from the bad oxygen sensor, and solder the wires to the new oxygen sensor. Step 4: Add a small amount of anti-seize to the threads of the new sensor. Step 5: Turn on the ignition key, Use the diagnostic scanner/reader to clear the code from the vehicle's

How Many Oxygen Sensors in a Car?

The number of sensors varies according to engine type: Traditional V6 and V8 have three oxygen sensors including a left bank and right bank sensor upstream and a downstream O2 sensor 4 cylinder transverse has an upstream and downstream O2 sensors V6 and V8 transverse have four oxygen sensors including a left or front bank upstream; right or rear bank upstream; rear of the engine; and a downstream sensor

Why choose the SSN oxygen sensor?

SSN Auto Parts works hard to create an environment of honesty, integrity, mutual trust, and dedication. The unique design makes it can work in multi-environment and large energy conversion. Each oxygen sensor is designed for specific applications, low emissions, and high energy output. We manufacture and distribute a full line of high-technology critical components.

⚠️WARNING: This product can expose you to chemical which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.